================================================================================
The 2.6 TS-UART drivers for the TS-BAT3 and the TS-RF2 board have been 
modified to support the TS-73XX series of boards (TS-7350,TS-7370,TS-7390).  
The change is transparent to existing use on the TS-7800.

To use these drivers on the TS-73XX it is only necessary to specify the 
base address for 8-bit ISA access, and the ARM IRQ number for the IRQs 
that may be used by the board.
For instance, the TS-RF2 board can use ISA IRQ6 or IRQ7, so the irq 
parameters to specify are irq6 and irq7.  The driver will automatically 
detect which IRQ is in use.

Depending on your setup it may also be necessary to turn alter the 
PC-104 MUX registers to set the pin functionality to ISA signals.  The 
examples below demonstrate commands which may be used to accomplish 
loading of the respective drivers.  (Note: both drivers still require 
tsuart1.ko to be loaded first.)

TS-RF:
peekpoke 32 0x600ff098 0x55555555
peekpoke 32 0x600ff09c 0x55555555
insmod ./tsuart-rf.ko io=0x600ff800 irq6=33 irq7=40

TS-BAT3:
peekpoke 32 0x600ff098 0x55555555
peekpoke 32 0x600ff09c 0x55555555
insmod ./tsuart-bat3.ko io=0x600ff800 irq5=32 irq6=33
================================================================================

